Until I open the editor again, or restart the modules 🤷♂️ Mind you I've not done any changes either, just open and close. I have the websocket package enabled, maybe that's good additional info.
💬
general Grid
Unable to change pages after quitting editor
Function Store - Dan · · 12 replies
Replies (12)
Greg-Orca · If you have an active change in the config, Page Change is blocked.
When you reconnect, the Editor no longer knows the module has an active change, so Page Change becomes unblocked and you can switch pages — but you will lose the unsaved changes.
Always store your changes before switching pages or unplugging the module.
Function Store - Dan · As I wrote, I made no change. Literally just open the editor and close it.
Function Store - Dan · Proof
Function Store - Dan · Function Store - Dan · @user
Function Store - Dan · Also no other software running. No DAW, no TD, this is right after booting my pc
Greg-Orca · I managed to reproduce it a few times. If I open the Editor while Grid on the third page, like you did, and then close the Editor, sometimes it blocks page switching from that point on.
It might be related to the two modules not being on the same page, as you mentioned in the other ticket. Also, when I clear the configs, I couldn’t reproduce it anymore — probably because the Editor blocks page changes until it fully loads the configs.
I’ll create an issue for it.
Function Store - Dan · They were on the same page fyi
Function Store - Dan · Thanks for looking into it
Function Store - Dan · To me it happens very consistently
Function Store - Dan · Also being on any page not only third
View on Discord
This post is from the Intech Studio Discord community.