Hi guys! I bought 3 En16 and I would like to replace actual knob caps (18mm height) by transparent low profil ones.
Let me explain. Because of nomad constraints, I want them low profil. Also, let's imagine a transparent cap that can cover the LED and spread the light (as a visual improvement).
So:
Cannot wait your answers, take care 😉
++
Tom
Greg-Orca · Hey Tom
Greg-Orca · we are using a custom made cap, but you can swap it out with most of the d-shaft cap, here is ours:
Greg-Orca · Transparent is a good idea, to see the LEDs or rotat the module 90 or 180 degree
faiscacax · Hi Greg, thanks for your reply.
I already got the PDF from the support but I wanted to know if this idea was completely stupid or not lol
Maybe not transparent but translucent 🤷
I will try to check if I see some exemples out there.
Greg-Orca · I think the transparent encoder is a good idea
View on Discord
This post is from the Intech Studio Discord community.