so I set up a patch in MiRack to trigger a CV value manually via the BU16. the problem is I can only trigger it once with the Grid controller. To have the grid controller recognized again I have to trigger the module in the app, then I can hit the BU16 once. but no more. i have wiped midi config over and over in MiRack and resetup different ways but nothing changes. I'm admitedly new to all of the software/hardware midi stuff. i am having to recreate my IRL hardware rig virtually so I can tour easier.
💬
general Grid
miRack midi grid not retriggering
aarontylerosborne · · 12 replies
Replies (12)
aarontylerosborne · here is a video of the problem. its hosted in AUM in this clip but does the same thing on non-hosted miRack
aarontylerosborne · aarontylerosborne · tried a different module and same thing.
aarontylerosborne · is there a "clear" command the keys need to send after triggering?
aarontylerosborne · A friend was messing with this patch using a Novation Launchkey controller and was able to get consistent triggering when they switched the midi message for the pad to Control Change and set the behavior to Momentary.
How do I do this on the BU16?
Greg-Orca · Hey,
In the Grid Editor, you can set up how the button behaves. I recommend trying to send a CC message and using a Press Release block — this way, the MIDI message is only triggered once when the button is pressed.
aarontylerosborne · 
aarontylerosborne · this is the config it needs
aarontylerosborne · so I clear out all the default blocks and add these press and release blocks?
aarontylerosborne · I GOT IT!! thank you!!
i am trying to virtualize the hardware setup I have for my electro-acoustic project ELECTROGONG and its been a slog.
Greg-Orca · Nice! If you're up for more fun, I recommend trying out the velocity sensitivity mode and pressure sensitivity mode—experiment with them!
If you add a button mode block you can choose of the modes.
aarontylerosborne · thank you!
View on Discord
This post is from the Intech Studio Discord community.